Neko's Sequencer System

Type a message or a segment sequence and get the Custom Pulse bitstring for each of your 18 lights, ready to paste in game.

Display & build plan

1
2
3
4
5
6
7
17
8
9
18
10
11
12
13
14
15
16

No sequence yet

The numbers are the light numbers used below. Build your array in the same layout, then set each light's bitstring by hand. Segments 17 and 18 are the outer wings; only a segment sequence reaches them.

Colour

Hex for the game
E03535FF

Paste into the hex field of Change Light Color. The last two digits are the opacity.

Sequence

Same value as the Flash Interval field in the game's Custom Pulse dialog.

Bitstrings

Attachment numbers
Attach. # LightBitstring
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18

How it works

  1. Build the array. Buy 18 lights and place them on your vehicle in the layout shown on the display. Keep the numbering: light 1 is the top-left bar, 17 and 18 are the outer wings. Every one of the 15 lights and 7 LED strips has the light controls; frames, plates and the coil stopper do not.
  2. Write the sequence. Type text such as ROAD CLOSED. Each character is one step, a space is a dark step. Or set segments yourself: (1 5 12) lights segments 1, 5 and 12 in one step, and (1 5)(8 9)(15 16) is a three-step animation. Text and groups can be mixed. The game's pattern grid has 16 steps, so longer input is cut off.
  3. Number your lights. Open a light in game and note the Attachment # it shows. Enter those numbers in the table: the rows sort by that number so you can step through #1, #2, #3 in game, and Shift all moves every number at once. The numbering is saved in this browser.
  4. Paste the bitstrings. For every light: Change Light Mode, Custom Pulse, then paste that light's line into the Bitstring field. The field takes only 0 and 1. Leaving it empty switches the light back to its built-in blink, so paste the zeros too: a light that never lights up in the sequence still gets its zeros, so all 18 lights stay in step. Set the Flash Interval to the value shown above. Rows you have copied stay marked until the sequence changes.
  5. Pick the colour. Choose a colour here, copy the eight-digit hex and paste it into Change Light Color for each light.

Supported characters

0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z - + / \ . < > = * ' ? | $ # %

Lower-case letters are shown as capitals. Parentheses cannot be displayed because they form the sequence syntax. On 18 segments a | looks the same as a 1; # and % are approximations.